VSC OPERATION AND MAINTENANCE INSTRUCTIONS 4 118 0324 2 IOM

3
Topvex FC
Compact Air Handling Unit
Operation and Maintenance Instructions
Document in original language
125918-EN_GB
2015-03-16 A001
Operation and Maintenance Instructions
Systemair AB
Danger
• Make sure that the Mains supply to the unit is disconnected before performing any mainte-
nance or electrical work!
• All electrical connections must be carried out by an authorized installer and in accordance
with local rules and regulations.
Warning
• The door handles are only intended to be used during the installation and service. These
must be removed before the unit is put into operation to ensure the required level of safety for
the unit.
• The unit must be duct connected or in some other way provided with protection so that it is
not possible to come in contact with the fans through the duct connections.
• The unit is heavy. Be careful during transport and mounting. Risk of injury through pinching.
Use protective clothing.
• Beware of sharp edges during mounting and maintenance. Make sure that a proper lifting
device is used. Use protective clothing.
• The units electrical connection to the mains supply must be preceded by an all pole circuit
breaker with a minimum 3 mm gap.
Caution
• If the unit is installed in a cold place make sure that all joints are covered with insulation, and
tape well
• Duct connections/duct ends should be covered during storage and installation
• Do not connect tumble dryers to the ventilation system
• Take care not to damage the water battery when connecting water pipes to connectors. Use
aspanner to tighten the connection.