Manual Infracalm

Infracalm
10
EN
Installation and operating instructions
Positioning
The heaters must be placed so that they
enclose the area to be heated, see g. The
normal assembly height is 2–2,5 metres
above the ground/oor. A rule of thumb for
infrared heaters equipped with metal tubular
elements is that 750–1000 W/m² increases the
experienced temperature by about 10°C. The
output demand can be reduced if the area to
be heated is protected. If the area only has a
roof, at least 1000 W/m² should be installed.
750 W/m² is sucient if the area has three
walls. For enclosed areas, the output demand
must be calculated. A green house for example
requires 250-300 W/m². Optimum comfort is
achieved if the heat is distributed from at least
two directions.
Mounting
Infracalm is installed horizontally on the ceiling
or on the wall with the supplied adjustable
mounting brackets. The angle of the heater
can be adjusted for optimum comfort. The
standard brackets cannot be used for angled
installation on the ceiling, because the
distance then becomes less than the minimum
distance. Infracalm can also be suspended
by wire. For minimum distance, see diagrams
on introductory pages. The distance between
the brackets is adjustable and can be chosen
according to the most appropriate place for
installation. The mounting brackets enable wall
mounting in three different angles; parallel to
the wall, 18° or 36° angle. For ceiling mounting
the bracket must always be mounted with 0° to
General Instructions
Read these instructions carefully prior to
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid should the product be used
in the manner intended and in accordance with
the instructions.
Application
Infracalm provides year round comfort to
wind protected outdoor balconies, patios and
restaurant terraces. Infracalm is also suitable
for temporary heating, e.g. in premises that are
used occasionally, or for spot heating.
Protection class: IP24.
Control
A stepless output control and a timer are
available for outdoor use.
When using this product as a local space
heater according to Ecodesign Regulation
(EU) 2015/1188, it must be supplemented with
one of the following approved controls.
• TAP16R, electronic thermostat that includes:
- Electronic room temperature control plus
week timer
- Room temperature control with open
window detection
- Adaptive start control
• TAP16R and SKG30, black bulb sensor that
include:
- Electronic room temperature control plus
week timer
- Room temperature control with open
window detection
- Adaptive start control
- Black bulb sensor
• TAP16R and PDK65, presence detector that
include:
- Electronic room temperature control plus
week timer
- Room temperature control with open
window detection
Connection
Infracalm is intended for permanent
installation. The installation, which should be
preceded by an isolator switch with a contact
separation of at least 3 mm, should only
be wired by a competent electrician and in
accordance with the latest edition of IEE wiring
regulations.
The terminal block, which also enables
connection to other heaters, is situated on the
same end of the heater as the data label. The
supplied cable gland are to be mounted in the
knock-outs. Please note that the inlet must be
tight. See wiring diagrams.
the ceiling. See the introduction pages.
• Choose the desired angle and fasten the
bracket onto wall or ceiling. The holes are
Ø5 mm, c-c distance is 25 mm.
• Fasten the heaters, snap into the brackets
and secure it by tightening the securing
screws (104 mm long) and the domed nuts
(spanner width 7 mm).