VTR 100B LITE Installation and Service manual v2

Installation |
17
Fig. 18 Placing the unit on the mounting bracket
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
Mounting the unit with the cooker hood installed using brackets
1. Pull the cooker hood power supply and control cables to the top since the mounted VTR 100/B LITE unit will block ac-
cess to the back.
2. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
3. Connect the cooker hood and the VTR 100/B LITE unit using flexible duct.
4.3.3.1 Wiring and configuration
1. Lead the cooker hood cables through a rubber grom-
met on top of the unit.
2. Connect control signal wires from the cooker hood to
digital input 2 (DI2) on the main board.
Note:
DI2 is pre-configured for cooker hood function.
Check and adjust airflow if necessary.
212962 | v02