VTR 100B LITE Installation and Service manual v2

Installation |
19
Fig. 21 Installation of hooks and mounting of the kitchen furniture panel
2. Sticker with marked holes (figure 21, pos. 1) is included with the unit. Holes mark spots for screws to secure hooks.
Place the sticker on a back of the kitchen furniture panel, figure 21, pos. 2), adjust position of the sticker according to
the panel size and position of the unit between cabinets. Size of the sticker is the same as the unit.
Once correct position is found, attach four hooks (figure 21, pos. 3) by fastening each with two screws (figure 21,
pos. 4). Hang the kitchen furniture panel on protruding bolts (figure 21, pos. A).
If the kitchen furniture panel does not align with cabinets, take it off and adjust bolts or hooks.
Note:
Distance between the unit and the panel can be adjusted from 15 to 25 mm. Use 50 mm bolts if distance
needs to be greater.
50 mm bolts are not included.
4.4.2 Mounting the kitchen furniture panel on sides of cabinets
The panel can be installed using included brackets.
212962 | v02