VTR 100B LITE Installation and Service manual v2

20
| Installation
Fig. 22 Installation of bolts and brackets
1. Install four M6 bolts into threaded inserts in brackets and lock bolts with hex nuts (figure 22). Bolts protrusion can be
adjusted later.
A cross screwdriver and a 10 mm spanner are needed. They are not included in the package.
Brackets are adjustable vertically (figure 22, A) and horizontally (figure 22, B). Align the brackets with the underside
of the unit. Fully tighten screws after adjusting the brackets.
Fig. 23 Installation of hooks and mounting of the cover
2. Install four hooks near the edges on the kitchen furniture panel. Sticker with marked holes (figure 23, pos. 1) is in-
cluded with the unit. Holes mark spots for screws to attach hooks. Place the sticker on a back of the kitchen furniture
panel, figure 23, pos. 2). Size of the sticker is the same as the unit. Manually mark out distances from the edges in
case the panel is bigger than the sticker.
Once correct position is found, attach four hooks (figure 23, pos. 3) by fastening each with two screws (figure 23,
pos. 4). Hang the panel on protruding bolts (figure 23, pos. A).
If the kitchen furniture panel does not align with cabinets, take it off and adjust bolts, brackets or hooks.
212962 | v02