UserManual AIAS201910

22/24 | User Manual AIAS | 201910
RC Units
Same menu points for
RC 2 ... RC 30
Dampers
Same menu points for
Mod 2 ... Mod 30
CONTINUES ON PAGE 22 CONTINUES ON PAGE 21
Assignment of the system addresses
to the physical devices, I/O values.
Mod 1
Connet RC
RC
Type
Assign Modbus VAV Mod
1 to corresponding room
controller (choose from RC 1
to RC 30)
Choose the type of the VAV
(supply or extract) Assigned
to the same room controller,
the system auromatically
operates the room in mas-
ter/slave mode (supply=M/
extract=S)
RC 1
PLA
ELA
Room controllers system address setup.
Each RC has a label with unique address.
Save this address here
Mod 1
Modbus Addr.
Manual Setp
Save the Modbus address
stored in the VAV controller.
It is recommended to set
the VAV modbus addresses
1 to 30 and then assign
them correspondingly to the
system registers Mod 1 to
Mod 30
Manual setpoint for the VAV
controller adjustable.