ACCESS QUICK CONFIG GUIDE SW 4 0 1 05 157618
Table Of Contents
- 1 About this document
- 2 How to set up a function
- 3 Save commissioning settings
- 4 Quick configuration guides
- 4.1 Editable naming
- 4.2 Alarm configuration
- 4.3 Fan control type (Pressure)
- 4.4 Temperature control type (Room)
- 4.5 Extended operation
- 4.6 Fan compensation
- 4.7 CO2 control (Fan start/stop)
- 4.8 Fire/Smoke function (Fire)
- 4.9 Free cooling
- 4.10 External cooler (DX)
- 4.11 External heater (Water)
- 4.12 Change over
- 4.13 External stop
- 4.14 Support control
4
| Quick configuration guides
3. Select the submenu related to the I/O to rename (e.g Analog inputs if temperature sensor)
4. Select the I/O function of which to rename (e.g Supply air temperature)
5. Edit the name of the I/O (in-/outputs) by selecting Name.
4.1.3 Sequence naming
Change the name of a heating/cooling sequence by selecting the desired sequence in the Configuration > Func-
tions > Function activation >Heating/Cooling sequence setup menu and changing the menu row Name.
Configuration > ... > ... > Heating/Cooling sequence
setup
04 Apr 13:54
Position
Heating Cooling
Start
Heating
Start
Cooling
Name
SEQ-H
Off
3 0 % 0 %
Cooling 2
>
Configuration >... > Heating/Cooling sequence setup >
Cooling 2
04 Apr 13:54
Name
Cooling 2
Original name Cooling 2
Step by step:
1.
Select Configuration from the navigation icons
2. Select Functions
3. Select Function activation
4. Select Heating/Cooling sequence setup
5. Select the sequence to rename (e.g Cooling 2)
6. Edit the name of the sequence by selecting Name.
4.1.4 Alarm naming
How to edit alarm names is described in chapter 4.2.
4.2 Alarm configuration
Configure any alarm available in the controller in the Configuration > Alarms menu.
Overview:
Configuration > ... > Extra alarm 1
04 Apr 13:54
Action: No action
Level: Disabled
Delay:
0 s
No:
68
Name:
Extra alarm 1
Step by step:
1.
Select Configuration from the navigation icons
157618 | A002