Installation, Operation and Maintenance instruction Protective hoods Topvex SR
Table of content 1 Introduction .......................................................... 1 1.1 Intended use .............................................. 1 1.2 Document description................................... 1 1.3 Product overview......................................... 1 1.3.1 Exhaust air hood ............................. 1 1.3.2 Outdoor air hood ............................. 1 1.4 Product liability............................................ 1 2 Safety .......................................
1 Introduction 1.1 Intended use 1.3.2 Outdoor air hood The product is used to weather protect the supply and exhaust connections. 1.2 Document description This document contains instructions for installation of the product. The procedures must be done by approved personnel only. 1.3 1.3.1 Product overview Exhaust air hood 1.
2 Safety 3 Installation 2.1 Safety definitions 3.1 To do before installation of product Warnings, cautions and notes are used to point out specially important parts of the manual. Warning If you do not obey these instructions, there is a risk of death or injury. Caution If you do not obey these instructions, there is a risk of damage to the product, other materials or the adjacent area. • Examine the packaging for transportation damage and remove the packaging from the product carefully.
4 To install the protective hoods Note: Attach the protective hoods before ODK roof. Caution Minimum two persons required for installation of product. 4.1 1 Exhaust air hood Position the hood with the cut-outs against the hinge of the air handling unit. Fasten the hood with the enclosed screws.
4.2 1 Outdoor air hood Position the hood with the cut-outs against the hinge of the air handling unit. Fasten the hood with the enclosed screws 4.
5
last page Systemair Sverige AB Industrivägen 3 SE-739 30 Skinnskatteberg 0222 440 00 info@systemair.se www.systemair.se © Copyright Systemair AB All rights reserved EOE Systemair AB reserves the rights to alter their products without notice. This also applies to products already ordered, as long as it does not affect the previously agreed specifications.
