Installation Instruction
Table Of Contents
- 1 Product information
- 2 Overview
- 3 Warnings
- 4 Unloading from trailer
- 5 Transport and storage
- 6 Unpacking
- 7 Duct connections
- 8 Internal components
- 9 Installation
- 10 Electrical connections
- 11 Connection of water heating coil
- 12 Access control system
- 13 Connect accessories in Control unit CU27-C
- 14 Dimensions and weight
- 15 Technical data
- 16 Additional equipment
- 17 Disposal
- 18 EU Declaration of Conformity
- 19 UK Declaration of Conformity
34
| Access control system
12.3.1 Connect NaviPad
Open the Access control cabinet figure 18. Unscrew the connection lid (1) and pull up the lid and comb with plugs that
seals the connection area. Brake loose the plug required to connect NaviPad (2). This also apply for other connections
to the control unit.
Connect NaviPad to the HMI port in the control unit in Access control cabinet. Lead the NaviPad cable in the cable clips
(2) and fasten with a cable tie to the strain relief (3). Lead also other cables in the cable clips and fasten with cables
ties.
Note:
24V HMI connection dedicated for the display. The connection is only for HMI and no other
connections is permitted.
Fig. 21
214958 | A007