ACCESS QUICK CONFIG GUIDE SW 4 0 1 05 157618
Table Of Contents
- 1 About this document
- 2 How to set up a function
- 3 Save commissioning settings
- 4 Quick configuration guides
- 4.1 Editable naming
- 4.2 Alarm configuration
- 4.3 Fan control type (Pressure)
- 4.4 Temperature control type (Room)
- 4.5 Extended operation
- 4.6 Fan compensation
- 4.7 CO2 control (Fan start/stop)
- 4.8 Fire/Smoke function (Fire)
- 4.9 Free cooling
- 4.10 External cooler (DX)
- 4.11 External heater (Water)
- 4.12 Change over
- 4.13 External stop
- 4.14 Support control
Quick configuration guides |
9
Step by step:
1. Select Data & Settings from the navigation icons
2. Select Temperature control
3. Select Room controller
4. Adjust Setpoint room to the desired temperature setpoint
5. Go back to Temperature control (use the navigation path Data & Settings > Temperature control)
6. Select Supply air controller
7. Set Min limit supply air to the lowest permitted supply air temperature
8. Set Max limit supply air to the highest permitted supply air temperature.
4.5 Extended operation
4.5.1 Activation
Select Yes on Extended operation in the Configuration > Functions > Function activation menu.
Overview:
Configuration > Functions > Function activation
04 Apr 13:54
Extended operation
Yes
Step by step:
1.
Select Configuration from the navigation icons
2. Select Functions
3. Select Function activation
4. Select Yes on Extended operation.
4.5.2 Configuration
Select which of the configured fan speeds to enable extended operation for in the Configuration > Functions >
Extended operation menu.
Overview:
Configuration > Functions > Extended operation
04 Apr 13:54
Extended operation low speed
No
Extended operation normal speed
Yes
Extended operation high speed
Yes
Step by step:
1.
Select Configuration from the navigation icons
2. Select Functions
3. Select Extended operation
4. Select Yes for desired extended operation fan speeds
157618 | A002