ACCESS QUICK CONFIG GUIDE SW 4 0 1 05 157618
Table Of Contents
- 1 About this document
- 2 How to set up a function
- 3 Save commissioning settings
- 4 Quick configuration guides
- 4.1 Editable naming
- 4.2 Alarm configuration
- 4.3 Fan control type (Pressure)
- 4.4 Temperature control type (Room)
- 4.5 Extended operation
- 4.6 Fan compensation
- 4.7 CO2 control (Fan start/stop)
- 4.8 Fire/Smoke function (Fire)
- 4.9 Free cooling
- 4.10 External cooler (DX)
- 4.11 External heater (Water)
- 4.12 Change over
- 4.13 External stop
- 4.14 Support control
12
| Quick configuration guides
4.6.3 Operation settings
Set up fan setpoint compensation values and sensor input values for the curve points in the Data & Settings > Fan
control > Fan compensation curves menu.
Overview:
Data & Settings > Fan control > Fan compensation curves
04 Apr 13:54
Fan compensation curve 1
>
Fan compensation curve 2
>
Fan compensation curve 3
>
Data & Settings > ... > Fan compensation curves > Fan
compensation curve 2
04 Apr 13:54
Compensation curve
Sensor
value
Compensation
Lowest sensor value
15.0 °C
0.0 Pa
Middle sensor value
20.0 °C
0.0 Pa
Highest sensor value
25.0 °C
0.0 Pa
Step by step:
1.
Select Data & Settings from the navigation icons
2. Select Fan control
3. Select Fan compensation curves
4. Select Fan compensation curve 1/2/3
5. Set up Lowest sensor value
a. Set the lowest sensor value for compensation as Sensor value
b. Set the desired fan setpoint compensation at that sensor value as Compensation
6. Set up Middle sensor value
a. Set a middle sensor value for compensation as Sensor value
b. Set the desired fan setpoint compensation at that sensor value as Compensation
7. Set up Highest sensor value
a. Set the highest sensor value for compensation as Sensor value
b. Set the desired fan setpoint compensation at that sensor value as Compensation
157618 | A002