SYSVRF Mini GB Outdoor unit Mini VRF OWNER MANUAL
4 1 3 Fig.1 1 2 air outlet air inlet 3 4 Fix leg Refrigerant piping connection part (connection part in side) NOTE All the pictures in this manual are for explanation purpose only. They may be slightly different from the air conditioner you purchased(depend on model). The actual shape shall prevail. 16kW complying with IEC 61000-3-12.
CONTENTS PAGE It is not good for your health to expose your body to the air flow for a long time. IMPORTANT SAFETY INFORMATION............................................................1 PARTS NAMES............................................................................................2 OPERATION RANGE.....................................................................................3 OPERATION AND PERFORMANCE................................................................
Force Cooling Control Force cooling control Button sw1 To avoid oxygen deficiency, ventilate the room sufficiently if equipment with burner is used together with the air conditioner. sw1 sw2 Arrange the drain hose to ensure smooth drainage. Incomplete drainage may cause wetting of the building, furniture etc. Never expose little children, plants or animals directly to the air flow. Adverse influence to little children, animals and plants may result.
Th e f u n c t i o n o f t e x t r u n c i r c u l a t e a s f o w l l i n g(8/10.5/18KW).
4.5 Cooling and heating operation The indoor unit of the intelligent inverter centralized air conditioner can be controlled solely, but the indoor unit in the same system can not run cooling and heating at the same time. When the Cooling and Heating operation confront with each other, the Indoor Unit which are running on Cooling Mode would stop and there will be Standby or No Priority displayed in the Control Panel. Those Indoor Units which are running on Heating Mode will run continuously.
Table 5-2 (8/10.
6. FOLLOWING SYMPTOMS ARE NOT AIR CONDITIONER TROUBLES Symptom 1: The system does not operate The air conditioner does not start immediately after the ON/OFF button on the romote controller is pressed. If the operation lamp lights, the system is in normal condition.To prevent overloading of the compressor motor, the air conditioner starts 3 minutes after it is turned ON.
Table 7-1 Symptoms Causes Solution Unit Unit does does not not start start Power failure. Power switch is off. Fuse of power switch may have burned. Batteries of remote controller exhausted or other problem of controller. Wait for the comeback of power. Switch on the power. ReplLocation: Replace the batterises or check the controller. Air flowing normally but but Air flowing normally completely can't can't cooling cooling completely Temperature is not set correctly.
7.2 Troubles and causes of remote controller Before asking for serving or repairing , check the following points. (see in Table 7-2) Table 7-2 Symptoms The fan speed can not be changed. Solution Check whether the MODE indicated on the display is "AUTO" When the automatic mode is selected, the air conditioner will automatically change the fan speed. Check whether the MODE indicated on the display is "DRY" When dry operation is selected, the air conditioner automatically change the fan speed.
SYSVRF AIR EVO HP Mini_OM EN - December 2015 Certified: www.systemair.com www.systemair.