SYSVRF2 INDOOR UNIT OM

●

For One-Way Cassette Type

Remove the air intake grille, hold the air intake buckle with two hands

and open the grille downwards, pull it to the inside, and push the filter

buckle to remove the grille.

Air filter

Fig.5-3

● For Floor Standing type

The filter is housed in the lower part of the unit in Version II and III to

take in air from below or from rear. To remove the filter in versions II

and III, perform the following steps.

It is housed in the front panel in Version I to take in air from the

front.

To remove the filter in Version I, do as follows.

Fig.5-9

Fig.5-10

■ Remove the air intake grille from the panel.

Air Outlet

Selection Switch

Special function filter

● For Console Type

Push the grille switches in the directions of the arrows. Then, open

the air intake grille downwards. Press the claws on the right and left

of the air filter down slightly, then pull them upwards.

Fig.5-6

Hold the tabs of the frame, and remove the claws in the four

places. (The special function filter can be maintained by washing

it with water once every six months. We recommend replacing it

once every three years.)

Fig.5-7

Fig.5-8

■ Two-way Cassette type

1) Push the inhalation grating toward one side(non-directional),

eg., rightwards as shown in Fig.5-11;

2) Press the right side of the inhalation grating and simutane-

ously push it rightward, as shown in Fig.5-11; at the same time,

pull out the left side of the inhalation grating to an angle about

45°;

3) Slide the inhalation grating to remove it completely, as shown

in Fig.5-12 and Fig.5-13.

Fig.5-4

Fig.5-5