SYSVRF2 CEILING IM

3
Fig.4-4
FOR ORIGINAL CONCRETE BRICKS
Install the hanging hook with expansible bolt into the concrete
deep to 45~50mm to prevent loose.
4.2 Wall Mounting Installation
Fig. 4-5
Hook
D
E
Washer
2.Hang the indoor unit on the hook.
Tapping screw
<6mm
Hook
1.Fix the hook with tapping screw onto the wall.(Refer to Fig. 4-8)
Fig. 4-6
Never throw or strike the controller.
Before installation, test the remote controller to
determine its location in a reception range.
Keep the remote controller at least 1 m away
from the nearest TV set or stereo. (It is
necessary to prevent image and noise
interference.)
Do not install the remote controller in direct
sunlight or close to a heating source such as a
stove.
Note that the positive and negative poles are in
the right positions when loading batteries.
CAUTION
Fig.4-1
Fig.4-2
Fig.4-3
WOODEN CONSTRUCTION
NEW CONCRETE BRICKS
Steel bar
Embedding screw bolt
(Pipe hanging and embedding screw bolt)
(Blade shape
insertion)
(Slide insertion)
Roof beam
Hanging screw bolts
Ceiling
Timber over the beam
Place the square timber transversely over the roof beam. Then
install the hanging screw bolts.
Inlaying or embedding the screw bolts.
4. INDOOR UNIT INSTALLATION
NOTE
This manual is subject to changes due to technological
improvement without further notice.
4.1 The units may be mounted vertically providing that
the correct clearances for positioning are maintained.
(Refer to Fig. 4-1 )
Version I