RC08A Remote control manual

Table Of Contents

OPERATIION

C) HOW TO SET A PROGRAM FOR DAILY ON/OFF OPERATION

1. Press the TIMER OFF button to select the desired timer.

2. Press the TIMER OFF button till the ON sign blinks.

3. Press the + or - button until the desired value is displayed.

4. Press the TIMER OFF button again, the OFF sign blinks.

5. Press the + or - button until the desired value is displayed.

6. Press the TIMER OFF button to activate the timer.

Press button to activate the supply aire flap to auto swing, if you push this button

again, the flap stops immediately.

Set vertical vanes to the front position during COOLING/DRY operation if humidity is

high.

If the vertical vanes are set to the left-most or right-most position, condensation may

form around the air outlet and drip off.

Do not move the flap with your hands when the air conditioner is running.

Use the button on the remote control to adjust the position of the flap. If

you move the flap by hand, the factual flap position and the flap position on the

remote control may no longer match. If this should happen, shut off the unit,wait

for the flap to close, and then turn on the unit again; the flap position will now

be normal again.

NOTES

Some functions of remote controller will not be available when the unit does not

support them! By resetting the remote control, shall totally remove the battery

for 10 seconds.By pressing the " " and " " together to switch the temperature

display between degrees Celsius and degrees Fahrenheit at power off status.

ADJUSTING THE AIR FLOW DIRECTION

Press and CLEAN button together to activate the horizontal louver. If you push

them together again to stop it immediately.(Only for selected models)