HAWAIR – Installation Operation Manual (IOM HAW 01 N 3GB)

10
Ø 55
েৢ
7.4. INSTALL THE PIPING HOLE
8. HYDRAULIC CONNECTIONS
1. Make the piping hole (Ø55) in the wall with a slight
downward slant to the outdoor side.
2. Insert the piping-hole sleeve into the hole to prevent the
connection piping from being damaged when passing
through the hole.
Wall pipe
Seal pad
Indoor Outdoor
8.1. INSTALL THE WATER DRAIN PIPE
1. For good draining, the drain hose should be placed at a
downward slant.
2. Do not wrench or bend the drain hose or flood its end by
water.
3. Wrap witch insulation materials when the long is drainage
hose passing through indoor.
Wrenched Bent
Flooded
8.2. THE PIPING CAN BE LEAD OUT FROM LEFT, LEFT REAR
When routing the piping and wiring from the left side of the unit, cutting off the
tailings from the chassis is necessary.
² Cut off the tailings 1 when routing the wiring only;
² Cut off the tailings 1 and tailings 2 when routing both the wiring and
piping.
Tailing 2
Tailing 1
Take out the piping from body case, wrap the piping electric wire,
water pipe with tape and pull them through the piping hole.
Left rear
Left
Hange the mounting slots of the indoor unit on the upper tabs of
the rear panel and check if it is firm enough.
The height of the installed location should be 2.5m or more from
the floor.
Mouting
plate
Fixing hook
Mouting
baord
Water drainage
pipe
Finally wrapit
with tape
Inlet side piping
insulation
Inlet water
side pipe
Outlet water
side pipe
Outlet side
piping insulation