EDM SYSHP MINI SPLIT 06 16

63
2.4 Hydronic box
2.4.1 Placement Consideraons
▪ Hydronic box should be installed in posions that are as close as possible to the heat emiers.
▪ Hydronic box should be installed in posions that are suciently close to the desired posion of the wired controller that the
controller’s wiring length limitaon will not be exceeded.
▪ In systems that are congured to heat domesc hot water, hydronic box should be installed in posions that are suciently
close to the domesc hot water tank that the temperature sensor wiring length limitaons will not be exceeded.
2.4.2 Mounng the hydronic box
▪ Fix the wall mounng bracket to the wall using appropriate plugs and screws.
▪ Make sure the wall mounng bracket is completely level. When the unit is not installed level, air might get trapped in the water
circuit resulng in malfunconing of the unit. Pay special aenon to this when installing the hydronic box to prevent overow
of the drain pan.
▪ Hang the hydronic box on the wall mounng bracket.
▪ Fix the hydronic box at the boom inside using appropriate plugs and screws. The hydronic box is equipped with 2 holes at
the boom outer edges of the frame.
Figure 3-2.12: Wall bracket
Figure 3-2.13: Hydronic box backside
Figure 3-2.14: Fix hydronic box
two people
two people
two people