OM SYSHP MINI SPLIT

1 ) Use straight head screwdriver to insert in the buckling position in the

bottom of wired controller, and spin the screwdriver to take down the back

cover. (Pay attention to spinning direction, otherwise will damage the back

cover!)

2) Use three M4X20 screws to directly install the back cover on the wall.

3) Use two M4X25 screws to install the back cover on the 86 electrician

box, and use one M4X20 screws for fixing on the wall.

4) Adjust the length of two plastic screw bars in the accessory to be

standard length from the electrical box screw bar to the wall. Make sure

while installing the screw bar to the wall, making it as flat as the wall.

5) Use cross head screws to fix the wired controller bottom cover in the wall

through the screw bar. Make sure the wired controller bottom cover is on

the same level after installation, and then install the wired controller back to

the bottom cover.

6) Over fastening the screw will lead to deforma tion of back cover.

Cutting place of left

down side wire outlet

Left down

side wire

outlet