OPERATION INSTRUCTIONS DANFOSS ENG

ManualsBrandsSystemair ManualsElectrical accessories VentilationFC102-37,0kW/73A-IP55, 150/50m - frequency converter, 380-480V, 37kW, 73A, IP55

Pulse

Programmable pulse 2/1

Terminal number pulse 29

, 33

/33

Max. frequency at terminal 29, 33 110 kHz (push-pull driven)

Max. frequency at terminal 29, 33 5 kHz (open collector)

Min. frequency at terminal 29, 33 4 Hz

Voltage level see chapter 8.6.1 Digital Inputs

Maximum voltage on input 28 V DC

Input resistance, R

approx. 4 kΩ

Pulse input accuracy (0.1–1 kHz) Max. error: 0.1% of full scale

Encoder input accuracy (1–11 kHz) Max. error: 0.05% of full scale

The pulse and encoder inputs (terminals 29, 32, 33) are galvanically isolated from the supply voltage (PELV) and other high-

voltage terminals.

1) FC 302 only

2) Pulse inputs are 29 and 33

Analog output

Number of programmable analog outputs 1

Terminal number 42

Current range at analog output 0/4–20 mA

Max. load GND - analog output 500 Ω

Accuracy on analog output Max. error: 0.5% of full scale

Resolution on analog output 12 bit

The analog output is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.

Control card, RS-485 serial communication

Terminal number 68 (P,TX+, RX+), 69 (N,TX-, RX-)

Terminal number 61 Common for terminals 68 and 69

The RS-485 serial communication circuit is functionally separated from other central circuits and galvanically isolated from the

supply voltage (PELV).

Digital output

Programmable digital/pulse outputs 2

Terminal number 27, 29

Voltage level at digital/frequency output 0–24 V

Max. output current (sink or source) 40 mA

Max. load at frequency output 1 kΩ

Max. capacitive load at frequency output 10 nF

Minimum output frequency at frequency output 0 Hz

Maximum output frequency at frequency output 32 kHz

Accuracy of frequency output Max. error: 0.1% of full scale

Resolution of frequency outputs 12 bit

1) Terminal 27 and 29 can also be programmed as input.

The digital output is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.

Control card, 24 V DC output

Terminal number 12, 13

Output voltage 24 V +1, -3 V

Max. load 200 mA

The 24 V DC supply is galvanically isolated from the supply voltage (PELV), but has the same potential as the analog and digital

inputs and outputs.

Specifications

Instruction Manual

8 8