Operation instructions Danfoss ENG

3 Mechanical Installation
3.1 Unpacking
3.1.1 Items Supplied
Items supplied may vary according to product configu-
ration.
•
Make sure the items supplied and the
information on the nameplate correspond to the
order confirmation.
•
Check the packaging and the adjustable
frequency drive visually for damage caused by
inappropriate handling during shipment. File any
claim for damage with the carrier. Retain
damaged parts for clarification.
130BD511.10
Type 12 / IP55 Tamb.45 C/113 F
V LT
MADE IN DENMARK
R
P/N: 131U3930 S/N: 010102G290
3.0kW(400V) / 4.0HP(460V)
IN: 3x380-480V 50/60Hz 6.5/5.7A
OUT: 3x0-Vin 0-590Hz 7.2/6.3A
o
CAUTION:
See manual for special condition/mains fuse
voir manual de conditions speclales/fusibles
WARNING:
Stored charge, wait 4 min.
Charge residuelle, attendez 4 min.
* 1 3 1
U
3 9 3 0 0 1 0 1 0 2 G 2 9 0 *
`
HVAC Drive
www.danfoss.com
T/C: FC-102P3K0T4Z55H1UGCXXXSXXXXAXBXCXXXXDX
Listed 76X1 E134261 Ind. Contr. Eq.
o
`
1
2
3
4
5
6
7
8
9
10
1 Type code
2 Order number
3 Power rating
4
Input voltage, frequency and current
(at low/high voltages)
5
Output voltage, frequency and current
(at low/high voltages)
6 Enclosure type and IP rating
7 Maximum ambient temperature
8 Certifications
9 Discharge time (Warning)
10 Serial number
Figure 3.1 Product Nameplate (Example)
NOTICE!
Do not remove the nameplate from the adjustable
frequency drive (loss of warranty).
3.1.2 Storage
Ensure that requirements for storage are fulfilled. Refer to
chapter 8.4 Ambient Conditions for further details.
3.2 Installation Environments
NOTICE!
In environments with airborne liquids, particles, or
corrosive gases, ensure that the IP/Type rating of the
equipment matches the installation environment. Failure
to meet requirements for ambient conditions can reduce
lifetime of the adjustable frequency drive. Ensure that
requirements for air humidity, temperature and altitude
are met.
Vibration and Shock
The adjustable frequency drive complies with requirements
for units mounted on the walls and floors of production
premises, as well as in panels bolted to walls or floors.
For detailed ambient conditions specifications, refer to
chapter 8.4 Ambient Conditions.
Mechanical Installation Instruction Manual
MG11AK22 Danfoss A/S © Rev. 11/06/2014 All rights reserved. 9
3 3