Air Distribution Products TUNE-S Control Damper Data Sheet
/8 | Dampers Table of Contents Description . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Design . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Ordering Codes . . . . . . . . . . . . . . . . . . . . . . . . 6 Installation, Maintenance & Operation . . . . . . . . . . . . 7 Transport & Storage . . .
Dampers | 3/8 Description Tune-S is a control and shut off damper for rectangular ducts. It is available in with blade tightness class C4, tested according to EN 1751. It is ideal for use as a control and shut-off damper where different parts of the system need to be airtight separated from each other It can be used on air handling units as outer shut-off damper or with modulating actuator as control damper. The damper can be supplied in a manual or motorized version with position indicator.
/8 | Dampers H H+40 Dimensions 70 W 128 W+40 140 H 100 128 Fig. 2: Dimensions of TUNE-S with actuator NOTE: For the type M0 the actuator is not included. H+40 Fig.
Dampers | 5/8 Tab.
/8 | Dampers Ordering Codes TUNE-SSize (mm) W×H Handle for manual adjustment Positioning type - 200 ... 1200 × 100 ... 1000 H Preparation for actuator M0 230 V actuator M1 24 V actuator M2 24 V, 0 V ... 10 V continuous actuator M3 230 V spring actuator M4 24 V spring actuator M5 24 V, 0 V ...
Dampers | 7/8 Installation, Maintenance & Operation Tune-S is mounted into the ductwork by a standard flange. The fixing bolts, nuts, clips and gaskets shall be delivered by the installation company. The damper cannot be installed carrying any mechanical loads from other structures. Dry indoor conditions with an operation temperature range of -20°C to +70°C in the duct, -20 °C ... +50 °C on the actuator with relative humidity up to 95% non-condensing conditions.
www.systemair.com Systemair Production a.s.
