CORRIGO VENTILATION 3.X USER GUIDE
Table Of Contents
- About this user guide
- About Corrigo
- Display, buttons and LEDs
- The menu system
- Navigating the menus
- Running mode
- Temperature
- Setpoint Supply air temperature control
- Setpoint Outdoor temperature compensated Supply air control
- Setpoint Cascaded room temperature control
- Setpoint Cascaded extract air temperature control
- Setpoint Outdoor compensated room temperature/extract air control
- Support control heating/Support control cooling
- Frost protection temperature
- Exchanger de-icing
- Heat exchanger efficiency monitoring
- Recirculation
- Extra controller unit
- Enthalpy control
- Air control
- Pressure control SAF (there are also corresponding menus for EAF)
- Flow control SAF (there are also corresponding menus for EAF)
- Manual frequency control SAF (there are also corresponding menus for EAF)
- Frequency control external
- Frequency control SAF with EAF slave/flow control (also available for opposite function)
- CO2
- Humidity control
- Time settings
- Access rights
- Other functions
- Index
Corrigo ventilation user guide, revision F The menu system
21
Timer Normal speed
There are 8 separate setting menus, one for each
weekday and one extra for holidays.
Holiday schedules take precedence over other schedules.
For 24 hour running, set a period to 0:00 – 24:00.
To inactivate a period, set the time to 00:00 – 00:00. If both periods of a day are set to 0:00 –
0:00, the unit will not run at normal speed that day.
If you want to run the unit from one day to another, e.g.
from Mon 22:00 to Tue 09:00, the desired running time
for the various days must be entered individually.
First Mon 22:00 – 24:00....
...then Tue 00:00 – 09:00.
Timer reduced speed
These settings will be ignored if single speed fans are
configured.
Should periods for normal speed and periods for reduced
speed overlap, normal speed takes precedence.
Structure and function is otherwise identical with Timer Normal speed.
Extended running
Digital inputs can be used to force the unit to start
although the timer says the running mode should be
“Off”.
For 2-speed fans and pressure/flow controlled fans, inputs for normal speed and reduced
speed can normally be used.
The unit will run for the set time. If the running time is set to 0 the unit will only run as long
as the digital input is closed.
Extra timer outputs 1…5
Up to 5 digital outputs can be used as timer controlled outputs. Only outputs which have
been configured will be shown. Each with individual week-schedules with two activation
periods per day.
Each timer output has 8 separate setting menus, one for
each weekday and one extra for holidays. Holiday
schedules take precedence over other schedules.
If the function Recirculation has been configured, Timer output 5 can be used for controlling
start/stop of the Recirculation function.
Normal speed
Monday
Per 1: 07:00 – 16:00
Per 2: 00:00 - 00:00
Normal speed
Monday
Per.1: 07:00 – 16:00
Per.2: 22:00 - 24:00
Normal speed
Tuesday
Per.1: 00:00 – 09:00
Per.2: 00:00 - 00:00
Reduced speed
Sunday
Per.1: 10:00 – 16:00
Per.2: 00:00 - 00:00
Extended running
60 min
Time in ext running
0 min
Timer output2
Wednesday
Per.1: 05:30 - 08:00
Per.2: 17:00 – 23:00