CORRIGO E VENTILATION VARIABLES FOR EXOLINE AND MODBUS 3.6 MANU

6 Chapter 1 Corrigo with EXOline, Modbus and BACnet communication
Device name
CorrigoVentilation
BBMD address
Device ID low
2640
Device ID high
0 (x10000)
Device name
This is the devices name that is shown on the BAS when a device is discovered.
BBMD address
The BBMD address (BACnet/IP Broadcast Management Device) is used for discovering devices that
are attached to different BACnet/IP subnets and separated by an IP router. The address is entered as
host:port, where “host” can be the host’s name if DNS is configured. If DNS is not configured, the
host address should be entered in the format “xxx.xxx.xxx.xxx”, followed by the port number (default
setting 47808).
Example: mybbmd:47808 (with DNS configured) or 10.100.50.99:47808
Device ID
The ID of a device, used to identify it on the BACnet network. This number cannot be duplicated
anywhere on the BACnet network and must therefore be unique. To set an ID value of 34600, the
low number would be set to 4600 and the high number to 3.
DHCP
The Dynamic Host Configuration Protocol (DHCP) is a network protocol used on Internet Protocol
(IP) networks for dynamic distribution of network configuration parameters, such as IP addresses,
DNS servers and other services. The Corrigo can be configured to either obtain an IP address from a
DHCP server (dynamic) or the address can be set manually (static).
If you wish to set a static IP address for the Corrigo, simply enter the IP address you wish to use along
with the subnet mask, gateway address and DNS server address:
TCP/IP 
DHCP: Yes
Set static IP 
Current IP
-
IP
192.168.001.234
Subnet mask
255.255.255.000
Current subnet mask
-
Current gateway
-
Default gateway
192.168.001.001
DNS
192.168.001.001
Current DNS
-