400896 Topvex FR Installation Instructions

Topvex FR800, FR1600, FR3800
Installation instructions
Systemair Inc.
10
1
Prepare the surface where the unit is to be mounted. Make sure that the surface is at, level and that it
supports the weight of the unit. Perform the installation in accordance with local rules and regulations.
2
Lift the unit in place.
Warning
Beware of sharp edges during the mounting and maintenance. Make sure that a proper lifting device is
used. Use protective clothing.
3
Install the unit by using mounting brackets tted on
the unit on delivery.
1 Warnings
The following admonitions will be presented in the different sections of the document.
Danger
• Make sure that the Mains supply to the unit is disconnected before performing any maintenance or
electrical work!
• All electrical connections must be carried out in accordance with local rules and regulations.
Warning
• In order for the unit to be considered safely installed the doors if equipped with handles have to be
locked with a key to prevent unauthorized or accidental opening
• The unit must be duct connected or in some other way provided with protection so that it is not
possible to come in contact with the fans through the duct connections
• The unit is heavy. Be careful during transport and mounting. Risk of injury through pinching. Use
protective clothing.
• Beware of sharp edges during mounting and maintenance. Make sure that a proper lifting device is
used. Use protective clothing.
Caution
• If the unit is installed in a cold place make sure that all joints are covered with insulation, and tape well
• Duct connections/duct ends should be covered during storage and installation
• Do not connect tumble dryers to the ventilation system
• Take care not to damage the water battery when connecting water pipes to connectors. Use a
spanner to tighten the connection.
Topvex FR03, FR06, FR08, and FR11
Installation instructions
206638
1
Systemair AB
Installation according to procedure below
Note:
If the unit is installed in the ceiling ensure that
the unit is pressed tightly to the mounting surface
before fastening the mounting brackets. Make
sure to use proper fastening device (screw/bolts)
considering the weight of the unit and the type of
surface it is tted to. The installation can only be
performed by an authorized installer.
Fig. 9 Possible installation positions
3.5 Installing the Unit
The unit must be installed in the following position
Position Description
A Installation at on the ground. Left and right connections are possible.
B Ceiling installation. Left and right connections are possible.
Table 7: Description of possible installation positions
B
A