SAVE VTR 150B INSTALLATIONV01 20210316

16
| Installation
Adjust bolts if shifting distance is less than 25 mm or use wood blocks in case the required distance is greater.
Fig. 19 Installation of bolts
1. Install four M6 bolts into threaded inserts on the unit and lock bolts with hex nuts (figure 19). Bolts protrusion can be
adjusted later.
A cross screwdriver and a 10 mm spanner are needed. They are not included in the package.
Fig. 20 Installation of hooks and mounting of the kitchen furniture panel
2. Sticker with marked holes (figure 20, pos. 1) is included with the unit. Holes mark spots for screws to secure hooks.
Place the sticker on a back of the kitchen furniture panel, figure 20, pos. 2), adjust position of the sticker according to
the panel size and position of the unit between cabinets. Size of the sticker is the same as the unit.
Once correct position is found, attach four hooks (figure 20, pos. 3) by fastening each with two screws (figure 20,
pos. 4). Hang the kitchen furniture panel on protruding bolts (figure 20, pos. A).
If the kitchen furniture panel does not align with cabinets, take it off and adjust bolts or hooks.
Note:
Distance between the unit and the panel can be adjusted from 15 to 25 mm. Use 50 mm bolts if distance
needs to be greater.
50 mm bolts are not included.
6.6.2 Mounting the kitchen furniture panel on sides of cabinets
The panel can be installed using included brackets.
254539 | v2