SAVE VTR 150B INSTALLATIONV01 20210316

10
| Installation
Fig. 8 Installation of the cooker hood
The cooker hood is attached directly to the bottom of the
unit. This option can be used when the whole unit with a
cooker hood will be shifted forward using wood blocks to
be alighted with the cupboards or when the cupboard size
matches the unit and no adjustments are needed. This
way the unit can be simply mounted directly on the wall
with already attached cooker hood.
Important
Follow instructions delivered with the cooker
hood how to prepare it before installation.
1. Place a circular insulation on the cooker hood connector to prevent air leaking (figure 8, pos. 2).
Insert the cooker hood directly into the unit (figure 8, A). Screw the cooker hood to the bottom of the SAVE VTR 150/
B unit (figure 8, pos. Y). The duct connector have to go into the unit. Make sure the duct connector is aligned with the
unit before starting (figure 8, pos. X). Use included screws and plastic spacers to prevent over-tightening which could
lead to bent cooker hood (figure 8, pos. 1).
Fig. 9 Placing the unit on the mounting bracket (the cooker hood is not shown)
2. Pull the cooker hood power supply and control cables to the top since the mounted SAVE VTR 150/B unit will block
access to the back.
3. Once all cooker hood cables at the back are led to the top, lift the unit and hang it on the mounting bracket.
Warning
Beware of sharp edges during mounting and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely vertical and horizontal once mounted on the wall. Check with a spirit
level.
Make sure there is at least 2 mm gap between the unit and the cupboard to prevent vibration noises.
254539 | v2