SAVE Commissioning recordv02 20191107

Advanced settings |
3
Function
Default setting
Set value
Status ON OFF
ON
Setpoint
40%
____%
3.5 Defrosting Control*
Function
Default setting
Set value
Mode Normal Soft
Normal
Hard
* Only available if heat exchanger type is selected as Plate.
3.6 Components
Make sure to record inputs and outputs of connected component and related sensors in sections 3.7 Input and 3.8
Output.
3.6.1 Heater
Function
Default setting Set value
Type
None None
Electrical
Water
Change-over*
Circulation Pump Start Temperature**
10°C
____°C
Circulation Pump Stop Delay**
5 min
____ min
* If Change-over is selected at heater type, the cooler type must be also set as Change-over.
** Only available if heater type Water or Change-over is selected.
3.6.2 Cooler
Function
Default setting Set value
Type None None
Water
Change-over*
Outside Air Temperature Interlock
10°C ____ °C
Circulation Pump Stop Delay**
5 min ____ min
* If Change-over is selected at cooler type, the heater type must be also set as Change-over.
** Only available if heater type Water or Change-over is selected.
3.6.3 Extra Controller
Function
Default setting Set value
Extra Controller Mode None None
Preheater
Heating
Cooling
Set-Point
0°C ____ °C
212925 | v02_1.8.0