SAVE VTR 300B SERVICE AND ACCESSORIES INSTALLATIONV1 20210616 121938589

Accessories
|
45
Note:
The maximum supported cable length is 50 meters.
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Go to Communication ⇒ HMI Address and change the address number. Repeat these steps for each connected
control panel.
Each control panel must have it’s own unique address number. No control panel should have the same address value
to function properly.
SAVE LIGHT configuration
1. Push and hold
button for 10 seconds to see a current control panel address value.
2. Press
button to increase and button decrease the value.
Address value can be changed from 6 to 10, default value is 10.
Address value Indication
6
Low airflow LED is on
7
Normal airflow LEDs are on
8
High airflow LEDs are on
9
Refresh mode LEDs are on
10
All LEDs are on
5.5.5 Presence detector
A presence detector is used to activate one of required functions when someone is present in the room.
Universal input can be easily re-configured to activate a different function.
Component/product — Article number:
• Presence detector/IR24 — 6995
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Go to Input menu. Select UNIVERSAL tab.
4. Select the universal input to which wire from the pres-
ence detector is connected.
If, for example, it is connected to UI3 on the connection
board, then select UNIVERSAL INPUT 3. Set signal
type as Digital Input and select your desired
function.
Any movement in the motion sensor working area will activate your selected function.
5.5.6 Push button
A push button is a simple mechanical button which can be used to activate one of many available functions.
Universal input can be easily re-configured to activate a different function.
Component/product — Article number:
• Push button — 9693
| v01