KPB Operating Instructions
KPB GENERAL INSTRUCTIONS The following instructions must be considered as an integral component of this product, and the installer person must take care to abide by them, and be sure that this manual is kept and its instructions respected for further manipulations of the product. The manufacturer, Systemair, stress the point of his request, that the product must be installed by a qualified person.
KPB When it is decided the life product is finished, all components or the product itself, susceptible of being dangerous, must be recycled of destroyed, always taken into account to damage as less as possible the environment. This product must be used only for the purpose it has been designed, and therefore it must be considered unsuitable or dangerous for any other purpose.
KPB Check control of the product components Make the shaft(s) turning by hand and make sure they turn freely. Clean the product before installation. Check that motor(s) turn on the right direction. Maintenance Check always the product before putting it at work, and after having remained at stand still for a long period of time. Check all bearings once a month, and if necessary, apply the suitable grease. Revise the belt(s) tightened once a month.
KPB GENERAL RULES REGARDING THE ELECTRIC SUPPLY TO THE PRODUCT According to the safety rules, products using electricity must be connected to an efficient ground electric gateaway. In case of doubt ask for a deep electric installation check and be sure that it is carried out by a qualified person. The manufacturer of this product will not accept any claim for damages caused by the lack of a ground wire in the installation.
KPB 6 Size Approx. weight without min./max.
Systemair HVAC Spain S.L.U. • C\ Montecarlo, 14 P.I. Uranga • ES-28942 Fuenlabrada Tel.: +34 (0) 91 600 29 00 • Fax: +34 (0) 91 607 03 09 general@systemair.es • www.systemair.