Quickguide Frico Control FCSA FCDA FCPA FCBA
FC Frico Control - Quick guide
8
EN
Start up
1. Check that all components and accessories are
enclosed.
2. Assemble and connect system, consult wiring
diagrams.
3. Power-up the system.
4. The system automatically identies all components,
even when they are added at a later stage.
5. Connecting a new product must always be made with
the power off.
System solution
A system consists of a control panel, FCCF, as well as an
optional number (1-63) of units (air curtains, access points or
control panels) and sensors. The set-point temperature and
the fan settings for the system are selected on the control
panel.
The control panel houses a built-in temperature sensor which
can be used, alternatively the products or zones are tted with
external room temperature sensors that have better sensor
positioning for local temperature control.
Heating blocked dependent on outdoor
temperature
With outdoor temperature information (FCOTX / FCTXRF /
outdoor temperature signal in FCBAP), heating is automatically
blocked when the outdoor temperature exceeds 15 °C. The set
point can be changed and this function can be deactivated, see
Settings.
C. System with several products with
external room sensors connected to
each product
External room temperature sensors
control each product, together with the
inlet sensor in each product.
D. System with several products, of which, at
least two products have external room sensors
and at least one product does not have an
external room sensor
External room temperature sensors control each
product it is connected to together with the inlet
sensor in each product. Products without sensors
are controlled by the control panel's temperature
sensor together with the inlet sensor in each
product.
A. System without external room sensors
The control panel's temperature sensor is
controlling together with the inlet sensor in
each product.
B. System with one external room sensor
One external room temperature sensor in
the system controls all products, together
with the inlet sensor in each product.