INSTALLATION OPERATION AND MAINTENANCE INSTRUCTION KV DUO KVK DUO KVK001

3 Transportation and
storage
Warning
Make sure that the product does not
become damaged or wet during
transportation. A damaged or wet
product can cause fire or electric shock.
• Before you move the product to the installation location,
examine the packaging for damages.
• Do not move the product by the cables, terminal box, fan
impeller, protection grille, inlet cone or silencer.
• If lifting equipment is used, make sure that the lifting
equipment can hold the weight of the product. Refer to the
name plate for information. Do not lift the product by the
packaging.
Warning
Do not walk below a lifted product.
• Keep the correct side of the packaging up during
transportation. Refer to the arrows on the packaging.
• Load and unload the product carefully.
• Keep the product in a dry and clean location during
storage. Make sure that the ambient temperature during
storage is between –10 and +30 °C. A stable ambient
temperature prevents damage from condensation.
• Keep the product in storage for maximum 1 year.
4 Installation
4.1 To do before the installation
of the product
• Make sure that you have the necessary installation
accessories:
– Refer to 13 Accessory overview page 31 for an over-
view of the accessories.
– If you install the product outdoors, it is necessary to in-
stall a weather protection roof.
– To decrease vibrations transmitted from the product to
the duct system, Systemair recommends to install vi-
bration dampers, fast clamps or flexible connections.
– If you install the product with free suction or free dis-
charge, it is necessary to install a protection grille.
Make sure that the safety distance agrees with the
standard DIN EN ISO 13857 and the standard DIN
24167–1.
• Use installation material with fire resistance rating for the
installation location.
• Examine the packaging for transportation damage and re-
move the packaging from the product carefully.
• Examine the product and all components for damage.
• Make sure that the motor effect and the fan performance
agrees with the expectations at the installation location.
• Make sure that the information on the name plate and the
motor name plate agrees with the operation conditions.
• Install the product in a location where there is space for
commissioning, troubleshooting and maintenance.
• Make sure that the installation location is clean and dry,
for full safety during electrical work.
• Make sure that the installation surface has sufficient ca-
pacity to hold the weight of the product.
• Refer to the airflow direction arrows on the name plate or
on the product to install the product in the correct position.
• Make sure that all cable glands are tight against the ca-
bles to prevent leaks.
4.2 To install the product
Note:
All fans can be installed in any angle.
5