126186 INSTALLATION MANUAL 392 10

INSTALLATION
The cooker hood is intended for installation
built into cupboards. The cooker hood is
equipped with a motorised damper, LED
lamps and metal mesh filter. Installation,
care, maintenance etc., are described in
these instructions.
TECHNICAL INFORMATION
Fig. 1
Measurements see Fig. 1
Electrical
installation
230 V ~ earthed.
Lighting LED 2 x 2 W
Max. connection
output for control
cable
900 W at 230 V~
INSTALLATION
Fixing parts, screws for mounting, etc. are
supplied with the cooker hood.
Electrical installation
The cooker hood is supplied with an electri-
cal cable and earthed plug for connection
to an earthed wall socket as well as a
control cable for connection to an external
unit or units. The junction box and wall
socket must be accessible after installation
is complete.
Replacement of damper hatch
N.B. Only applicable where basic ventilation
takes place via the cooker hood.
The cooker hood is fitted with a sealed
damper. If the cooker hood is used in a kit-
chen that does not have separate basic
flow ventilation, it must be fitted with an ad-
justment hatch for basic flow. Replace the
damper hatch before installing the cooker
hood, see separate instructions
Assembly of connecting sleeve
coupling with damper
Fig. 2
The outlet air terminal device is supplied,
fitted inside the cooker hood.
The damper shaft A should be positioned in
the eye under the damper cover; see Fig. 2.
Make sure that the tabs B end up under the
edge of the plate and that the device snaps
into place.
18
991.0434.495/126186/2017-02-08