126186 INSTALLATION MANUAL 392 10

Installing the cooker hood
Installation between or in cupboards
without bases.
Fig. 3
The cooker hood is installed using
brackets.
Mark out and fasten screws so that they
protrude a few millimetres from both cup-
board sides as illustrated, Fig. 3A. If it is in-
tended to align the underside of the cooker
hood with the underside of the row of cup-
boards, use the upper measurement 102;
see Fig. 3A. The cooker hood brackets are
adjustable to fit various cupboard depths,
Fig. 3B.
Fig. 4
Move the cooker hood brackets without ful-
ly tightening the screws and adjust the
brackets so that they fit the sides of the
cupboards, Fig. 4A. Hang the cooker hood
in the pre-installed screws in the side of the
cupboard. Tighten the screws in the bracket
and on the wall, Fig. 4B. Lock the brackets
into position using the locking screws, Fig.
4C.
Installation in cupboards with bases.
Fig. 5
Fig. 6
The cooker hood is installed using
brackets.
Using a saw, cut out a hole in the base of
the cupboard, Fig. 5. Attach the brackets as
far into the cooker hood as possible. Insert
the cooker hood up into the hole in the
base of the cupboard. Pull out, Fig. 6A, and
use screws to fasten the brackets to the si-
des of the cupboard, Fig. 6B. Tighten the
brackets in the cooker hood.
Connection to exhaust flue
Connect the cooker hood with a pipe or
tubing Ø 125 mm.
991.0434.495/126186/2017-02-08 19