DXRE 172390 04

DXRE

To t the droplet eliminator

Droplet eliminator DE must be installed downstream of the

cooling coil in the duct cooler.

Fitting is done according to seperate instruction.

Cleaning

In order to ensure full capacity of the duct cooler, the nned coil

and droplet eliminator, if tted, must be regularly cleaned. e

intervals between cleaning are entirely dependent on the clean-

liness of the air and on how well the lter and the remainder of

the system are maintained.

CAUTION. Make sure there is no one below the drip tray when

it is being removed.

Modell B mm H mm S mm R mm I mm O mm K mm M mm

N ∅

C ∅

Coil inside

volume, l

DXRE 400x200-3-2,5 438 238 56 105 60 95 165 51 19 1/2’’ 0,81 DE 40x20

DXRE 500x250-3-2,5 538 288 56 105 60 50 165 41 22 1/2’ 1,23 DE 50x25

DXRE 500x300-3-2,5 538 338 56 105 60 50 165 54 22 1/2’’ 1,48 DE 50x30

DXRE 600x300-3-2,5 638 338 56 105 60 50 165 54 22 5/8’’ 1,72 DE 60x30

DXRE 600x350-3-2,5 638 388 56 105 60 50 165 54 22 5/8’’ 2,00 DE 60x35

DXRE 700x400-3-2,5 738 438 56 115 110 50 160 60 35 5/8’’ 3,25 DE 70x40

DXRE 800x500-3-2,5 838 538 86 115 140 50 160 60 35 5/8’’ 4,53 DE 80x50

DXRE 1000x500-3-2,5 1038 538 86 115 140 50 160 60 35 5/8’’ 5,46 DE 100x50

Remove the condensate outlet and blank o the connector so

that any remaining condensate will not run out. Remove the

drip tray by releasing the excentric lock on the front. Lower the

drip tray about 2 – 3 cm and then move it towards the back so

that the locking mechanism at the back will be released. e

drip tray is held captive by hinges the rear, but it can easily be

released to enable it to be removed from the cooler. If a droplet-

eliminator is tted, push the holder to the side and remove the

droplet eliminator for cleaning with compressed air or warm

water. Use a soft brush to clean the inlet side of the coil, and

the entire coil can then be cleaned with compressed air or by

vacuum cleaning. Blow the dirt away in a direction away from

the air outlet side and towards the inlet side. Take care not to

deform the edges of the ns. Clean the bottom of the drip tray,

and check that no dirt is lodged in the condensate outlet.

en ret the droplet eliminator, drip tray and anti-condensa-

tion insulation.