Installation , Operation and Maintenance Instructions Genius

2 Important Safety Information
2.1 Safety Notes
Observe the following safety instructions:
• Any work on the unit and rst commissioning must be carried out by an expert technician.
• The expert technician is responsible for installation and rst commissioning according to the applicable rules and regulations.
• Operate the unit only completely installed and with all safety devices.
• Check the lter regularly for contaminations.
• Never readjust the room supply and extract air valves. They will be adjusted during commissioning.
• Never modify the internal electrics and control.
• Operate the combi unit permanently with frost protection.
• As well as the fresh and exhaust air pipes, all the supply air pipes must be insulated so they are airtight.
This prevents heat losses during heating as well as condensation during cooling operation.
• For very cold external temperatures, a preheater for the heat pump (accessories) is needed to ensure operational reliability.
Systemair offers the heater as an option and also incorporates it in the plan, so that it is possible to retrot it if required.
• Do not use the ventilation system while the oor screed is drying, because damage to the ventilation unit may occur due to the
formation of excessive condensation. Any operation during the building phase must be excluded to prevent contamination of the duct
network and the unit.
• If commissioned in winter, the rst heating-through of the building must be performed by the builder/client on-site.
• Reheating elements are absolutely necessary for low-energy houses (for covering peak loads), as well as standard energy-efcient
houses. The use of reheating elements (accessories) is recommended for all house standards (activated for "defrost" mode-comfort,
emergency function).
WARNING
Electric shock
Electrics and electronics can become a lethal danger through ingress of liquids.
» The device shall not be exposed to dripping or splashing!
WARNING
Burning hazard
Risk of scalds with water temperatures higher than 43 °C.
» Do not open the hot water storage tank!
WARNING
Impacts and crushing
The ventilation module is not xed to the base module with bolts. At a gradient of more than 30°, the ventilation unit
can tip and fall down.
» Do not tilt the unit more than max. 30° from the vertical position!
» Wear a helmet!
7
Genius - V 1.0
Important Safety Information