Installation , Operation and Maintenance Instructions Genius

10.10.1 Command Add signal
Add signal
Figure 28: Add signal
Add signal:
1. Select a value in the Add signal window.
2. Decide whether the value should appear on the left or right scale.
3. Repeat 1 and 2 for all the values that you want to record.
The recording starts.
Adjust the vertical scale values : + / - and up / down buttons
" Reduce the highlighted scale by the + button.
" Increase the highlighted scale by the - button.
" Move the highlighted scale up with the up button.
" Move the highlighted scale down with the down button.
TIP
It may be useful to record the status of the unit (rotor operation, defrost, etc., illustrated with gures, see above) on a
scale of 0 to 10. Display a second scale in parallel with values from 0 to 100 to capacity demand, supply air tempera-
ture etc.
Change the horizontal time scale: + / - and left / right button
" Reduce the scale with the + button.
" Increase the scale with the - button.
" Move the scale to the left with the left button.
" Move the scale to the right with the right button.
82
Operation/Control via Internet/App
Genius - V 1.0