Manual Infrasmart IP24

Infrasmart IP24 - IHSxxx24
6
EN
Installation and operating instructions
Positioning
The heaters must be placed so that they
cover the area to be heated, see fig. 1. The
normal mounting height is 2–3 metres above
the ground/floor. A rule of thumb for infrared
heaters is that 600–800 W/m² increases the
experienced temperature by about 10 °C. The
output demand can be reduced if the area to
be heated is protected. If the area only has a
roof, at least 800 W/m² should be installed.
600 W/m² is sufficient if the area has three
walls. For enclosed areas, the output demand
must be calculated. Optimum comfort is
achieved if the heat is distributed from at
least two directions.
Mounting
IHS is installed horizontally on walls with
supplied bracket. For other mounting
alternatives, e.g. in the ceiling, under a
parasol or awning, see accessories. For
minimum distance, see diagrams on
introductory pages.
Replacing the lamp
The heat lamp is of the highest quality and
unless it is subjected to mechanical strains in
the form of vibrations and impact it will last
for a long time. The service life is dependent
on the ambient temperature and how the
heater is installed. When the heater is
installed freely and outdoors, the temperature
will be low and the life of the lamp longer.
The lamp must be replaced by an installer or
other skilled person.
1. Disconnect the power supply.
2. Wait until the unit is cold.
3. Check that the replacement lamp has the
correct output and voltage.
4. Fit the new lamp. Note do not touch the
lamp with your fingers, wear gloves or the
like.
5. The protective tube must be refitted to the
cables, so that the cables are not damaged
when the grille is fitted.
6. Reassemble the unit again.
General Instructions
Read these instructions carefully prior to
installation and use. Keep this manual for
future reference.
The product may only be used as set out in
the assembly and operating instructions. The
guarantee is only valid should the product
be used in the manner intended and in
accordance with the instructions.
Application
Infrasmart is a compact, halogen infrared
heater which can be controlled via an app,
remote control (included), or built-in push-
button. The Frico Infra app is available for
both iOS and Android. It has a range of up to
50 m and can control up to 8 infrared heaters.
Infrasmart is available in several IP classes
and colours. They are suitable for balconies,
outdoor areas and terraces.
Start-up
When the unit is used for the first time or
after a long period of non-use, smoke or an
odour may result from dust or dirt which has
collected on the element. This is completely
normal and disappears after a short time.
Connection
IHS is equipped with a 1.9 metre cord with
plug for connection to an earthed outlet
socket. The connection cord must not rest
against the unit as the surface becomes hot or
can be hit by thermal radiation. Contact an
electrician if the cord needs to be changed. As
the halogen lamp has a high starting current
the wall socket should be fuse protected by a
slow burn fuse.
In the event of uncertainty contact an
electrician.
Avstånd