Original instructions IHMC6-3 FR .... 2 GB ....
IHMC6-3 INSTALLATION AND OPERATING INSTRUCTIONS General Instructions Read these instructions carefully before installation and use. Keep this manual for future reference. The product may only be used as set out in the assembly and operating instructions. The guarantee is only valid if the product is used in the manner intended and in accordance with the instructions.
IHMC6-3 INTRODUCTION The IHMC6-3 is a microprocessor based power controller which has been designed to offer variable control for 3 separate 2kW loads from a 3-phase supply. The units have been manufactured to offer easy installation and functionality. The system consists of three elements: A HMI unit 1 (Human Machine Interface) which is wired via a low voltage 4-core cable to the main power unit 2, this then allows the operator to vary the output from off and 30% to 100% via a 10 step output.
IHMC6-3 TEST APPLICATIONS Any application were high inrush current is an issue or control is required. Typical use is for Infrared Heating lamps and Garden lighting.
IHMC6-3 SYSTEM PARTS HMI The HMI allows the user to control up to 9 individual BHC4002-ER units either via the push buttons on the HMI or via the Remote Handset and depending on selected configuration control the outputs by varying the settings from 1 to 10. All together you can preset 6 individual outputs with a maximum rating of 36kW dependant on configuration. The HMI can switch off all the outputs together or on an individual basis.
IHMC6-3 INSTALLATION CIRCUIT Table A Table B Neutral 3 phase supply 400V AC 50Hz Earth 4 core low voltage cable Load 1 Output Max. 2kW 12 Load 3 Output Max. 2kW Load 2 output Max.
IHMC6-3 CONFIGURATION OPTIONS The IHMC6-3 has been designed and tested to allow each controller to be mapped to either 2 channels (2 power level settings per 2 outputs) or 1 channel (1 power level setting per 2 outputs). Please note that no mapped channels should appear with the same channels numbers. Here are some examples using 3x IHMC6-3 on a 1 phase supply.
Tel: +46 31 336 86 00 mailbox@frico.se www.frico.net For latest updated information and information about your local contact: www.frico.net.
