User's Manual

Eddy User's Guide
14
Classification Specification
Console Port DB9 Male
Switch
Power ON/Off switch
Serial RS422/485 Termination resistor configuration switch
GPIO input test switch(Off : Low, ON : High)
LED RDY, Power, 34 Programmable IO, Console & Serial TxD, RxD LED
JTAG Port Used for downloading code and single-stepping through programs
Reset Button
Factory Default & Warm Boot
(If pushing over 5sec, operate in Factory default)
JIG Connection Socket 2 2x23pin socket, which connect JIG board to confirm problems
Expansion Header 2x22pin Header, used to test GPIO of Eddy-S4M
Input Power 5 VDC
Dimensions 160 x 120 mm
2.6 Eddy-S4M-JiG v2.1 (Testing Board)
Eddy-S4M JIG board is test board which enable of user to integrate and test their application with Eddy-S4M. JIG board include mini connector for joining
Eddy-S4M, Ethernet RJ45, USB Host, Power, Reset Switch, and providing connectors to all Eddy-S4M functions.
For more information, please refer to Eddy-DK manual in DK product.
Classification Specification
USB Connector USB HOST
LAN Port RJ45 with Transformer
Reset Button Factory Default & Warm Boot
Expansion Header
Used to connect most functions of S4M to externalS4M
Input Power 5 VDC
Dimensions 70 x 105 mm