User's Manual

ManualsBrandsSystemBase ManualsElectronicsEmbedded WiFi Module

Eddy User's Guide

Connection Type DHCP

Sets an IP address type in a wireless network.

(Option: DHCP, Static IP)

•DHCP : Assign a dynamic IP address through a DHCP server.

•Static IP : Specify an IP address manually.

IP Address 192.168.1.72

Sets an IP address of a wireless network.

If the line Type is Static IP, a user can enter an IP address directly. If line type is DHCP, the current IP

address is displayed. In DHCP type, the address cannot be changed.

Subnet Mask 255.255.255.0

Sets an IP address of a wireless network.

If the line Type is Static IP, a user can enter a subnet mask address directly. If line type is DHCP, the

current subnet mask address is displayed. In DHCP type, the address cannot be changed.

Gateway 192.168.1.1

Sets a gateway address of a wireless network.

If the line Type is Static IP, a user can enter a gateway address directly. If line type is DHCP, the

current gateway address is displayed. In DHCP type, the address cannot be changed.

DNS 168.126.63.1

Sets a DNS server address of a wireless network.

If the line Type is Static IP, a user can enter a DNS server address directly. If line type is DHCP, the

current DNS server address is displayed. In DHCP type, the address cannot be changed.

5.6 Peripheral Settings

Configure operation mode and output value for each Programmable I/O pins.

Eddy includes GPIO pins that output 3.3V or detect 3.3V signals.

Eddy-CPU provides 56 GPIO ports, if you only use WAN port.

You can detect either any 3.3V signals from external device, or output 3.3V signal to the external device. You can also program a customized GPIO application,

and you can implement it with the SDK included in the Eddy development kit.

Eddy-S4M provide 34ea GPIO port, different from Eddy-CPU, the sharing device is limited to ADC.

After changing values, you need to click ‘Submit’ button. Then you will see the same page with modified values. Please note that you have to ‘Save

& Reboot’ in order to see these changes in effect. Changes will be discarded if you do not save current settings.

Menu Default Descriptions

Device

Select

Eddy

Set the GPIO port to current pin’s I/O mode.

Eddy: Set Eddy defined mode.

GPIO: Set only GPIO port mode.

User: Set only user mode.

Value Output(Low)

Select the GPIO port to the specified mode.

Input(Pull-up): Standby with setting the GPIO to Vcc.

Input(Pull-down): Standby with setting the GPIO to Gnd.

Output(Low): 3.3V is not flowed through the port.

Output(High): 3.3V is output through the port.