User's Manual

Eddy User's Guide
56
Chapter 6. Configuration via Telnet
6.1 Connection
Open your telnet client and enter Eddy’s IP address to connect. You need to enter appropriate username and password to login. Please note that this
username and password is used as authentication method for Web as well. This means if username or/and password has been modified from the telnet
interface, modified values have to be entered to connect to web, and vice versa.
◆ Factory default username : eddy
◆ Factory default password : 99999999
Connection via Telnet
[def] command - you can view or configure Eddy’s settings
[def help] command - you can see help for [def] command
After changing values, you can see modified values with [def view] commands. But be careful because these values are not in effect unless you issue a
[def save] command. Changes will be discarded if you do not save current settings.
6.2 View commands
Commands related to View are as follows.
Commands Descriptions
def view Show all information about Eddy.
def view wan Show WAN network settings.
def view lan Show LAN network settings.
def view wifi Show WiFi network settings.