User's Manual

Eddy User's Guide
63
Chapter 7. apendix
7.1 Firmware Updates via FTP
Eddy supports firmware update with Web or FTP. This section describes update method via FTP and Telnet. Web update is described in Chapter 5. Configuration
via Web.
1) Connect to Eddy with FTP, using correct username and password. (Default: eddy, 99999999)
2) Issue a command ‘bin’ for binary file transfer mode. Optionally use ‘hash’ to see the data transfer mark.
3) Issue ‘put’ command upload the firmware file.
4) After getting a ‘Transfer complete’ message, issue a command ‘quit’ or ‘bye’ to disconnect. Now we are ready to update the
firmware.
Firmware updates via FTP
5) Connect to Eddy with Telnet, using correct username and password. (Default: eddy, 99999999)
6) After the login, you are already at the default directory where the firmware resides. Update can start right away.
7) Issue a command ‘ls’ to make sure firmware files are both successfully uploaded.
8) Use ‘upgrade’ command to write this file into Eddy’s Flash memory. Upgrade application automatically detects whether the given
firmware is kernel or file system.
9) Usage: upgrade <firmware filename> (Filename is case-sensitive.)
10) Make sure ‘Flash Write OK’ and ‘Flash Verify OK’ messages are displayed.