DataSheet_SB16C1053APCI_v106

SB16C1053APCI
PCI Target Controller with 2 Serial, 1 Parallel and MIO Bus
PCI to 2S+1P with MIO Bus Bridge
JULY 2013 REV 1.06
11
5.3 Serial 2-port and Parallel 1-port (2S 1P)
Serial 2-port and Parallel 1-port (2S1P) is generally made with SB16C1053APCI (called
by 2S1P Mode). Special logic is not needed to make one serial port since Dual-UART
and IEEE1284 compatible Parallel Port is built inside the SB16C1053APCI. The
Parallel Port supports all IEEE1284 standard protocols – Compatibility, Nibble, Byte,
EPP and ECP mode). SB16C1053APCI is used as a PC add-in card type in Figure 5–3
Figure 5–3: Serial 2-port and Parallel 1-port Mode Application
Block Diagram
5.4 Parallel 1-port (1P)
Parallel 1-port is generally made with SB16C1053APCI (called by 1P Mode). Special
logic is not needed to make one parallel port since IEEE1284 compatible Parallel Port
is built inside the SB16C1053APCI. SB16C1053APCI is used as a PC add-in card type
in Figure 5–4
Figure 5–4: Parallel 1-port Mode Application Block Diagram
Single-UART
MIO Bus
InterfaceC
O
N
1-port
Parallel
CON
32-bit PCI Local Bus, 66/33MHz
2-port Serial
Signals
C
O
N
C
O
N
Single-Parallel
Single-UART
SB16C1053APCI
MIO Bus
Single-UART
Interface
C
O
N
1-port
Parallel
32-bit PCI Local Bus, 66/33MHz
Single-Parallel
Single-UART
SB16C1053APCI