DataSheet_SB16C1053APCI_v106

SB16C1053APCI

PCI Target Controller with 2 Serial, 1 Parallel and MIO Bus

PCI to 2S+1P with MIO Bus Bridge

JULY 2013 REV 1.06

Table 7–2: Serial EEPROM Information Table

Address

Description

00h

Auto Load Tag (55h)

01h

Vendor ID Low Byte

02h

Vendor ID High Byte

03h

Device ID Low Byte

04h

Device ID High Byte

05h

Revision ID

06h

Sub Vendor ID Low Byte

07h

Sub Vendor ID High Byte

08h

Sub System ID Low Byte

09h

Sub System ID High Byte

0Ah~

Reserved

Vendor ID : Represents manufacturer of device. It is a unique ID given by PCI SIG and

must be downloaded from external serial EEPROM. If you do not own Vendor ID, you can

use 14A1h given to SystemBase by PCI SIG with permission.

Device ID : A unique ID of each device and is assigned at manufacturer’s discretion and

must be downloaded from serial EEPROM. If you do not prepare Device ID, you can use

SystemBase’s OEM Device ID (please contact SystemBase’s technical support).

Revision ID : It is a value representing device revision and must be downloaded from

serial EEPROM. You have to use B0h.

Sub Vendor ID : Shows information about Subsystem manufacturer. Generally, Vendor ID

or Device ID is information about Controller chip and Sub Vendor ID or Sub System ID is

information about manufacturer who made the product with the chip.

It must be downloaded from serial EEPROM. If you do not prepare Sub Vendor ID, you

can use 14A1h given to SystemBase by PCI SIG with permission.

Sub System ID : You can think of this as a Subsystem manufacturer’s own Device ID.

It must be downloaded from serial EEPROM. If you do not prepare Device ID, you can

use SystemBase’s OEM Device ID (please contact SystemBase’s technical support).