User's Manual

CAREU P2 Personal Tracker User Guide
15
4.2. Positioning
Setting regular timed interval or distance travelled interval reports.
AT$PDSR Position and device status reporting settings
Description
Position and data shall be reported when the device is moving. Reporting
shall be based upon satisfying a minimum time requirement and minimum
distance requirement
Syntax
Write Command:
AT$PDSR=<Mode>,<Min. Time>,<Min. Distance>,< Reserve >,
[<Destination>,< Reserve >,<Reserve>,<Time Multiplier>,<IgnoreGPS>]
Read Command:
AT$PDSR?
Parameters
<Mode>
0 – Disable
Bit 0(2^0 = 1) – Time Mode
Bit 1(2^1 = 2) – Distance Mode
Bit 2(2^2 = 4) – Reserved
Bit 3(2^3 = 8) –Reserved
Bit 4(2^4 = 16) – Time or Distance Mode
You can set two or more conditions like 3(1+2) for
ignition on and time conditions.
Bit 4 can’t be set with Bit 0 or Bit1 simultaneously.
<Min. Time>
Minimum Time in seconds that must elapse before
reporting next position. (1 – 65535)
<Min. Distance>
Minimum Distance in meters that must be traveled
before reporting next position. (25 – 50000)
<Reserve>
0
<Destination>
Bit 0 – Log to Data Queue
Bit 1 – Transmit GPRS
Bit 2 – Reserved
Bit 3 – Transmit SMS
< Reserve >
0
<Reserve>
0
<Time Multiplier>
1 – The PDSR Log and GPRS messages will be
sent according to the <Min. Time> setting.
n – The PDSR Log messages will be performed
according to the <Min. Time> setting, the PDSR
GPRS messages will be sent according to <Min.
Time> times n. (2 – 65535)
<IgnoreGPS>
0 – Continuously tracking regardless of GPS
signal.
1 – Ignore no GPS signal tracking report.
BV Certificate Use
2017/02/06 17:09