User's Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. The Device
- Chapter 3. Getting Started with CAREU P2
- Chapter 4. Using the CAREU P2
- AT$SGF Self Geo-fence alert settings
- AT$SGFEN Self Geo-fence alert enable
- AT$PDSR Position and device status reporting settings
- AT$DOWN Man Down Detection settings
- AT$DOWNEN Man Down alert enable
- AT$SOS SOS Tracking Report Configuration
- AT$BLEEN BLE alert enable
- Chapter 5. About Systems & Technology Corp.
- Chapter 6. Declaration
- Chapter 7. Regulations
CAREU P2 Personal Tracker User Guide
22
4.6.2 P2 Station Pairing
Upon powering up the P2 Station, the station automatically enters Scanning Mode to scan
within its proximity for all previously paired CAREU P2 units. When a CAREU P2 unit is
already paired, the number LED on the P2 Station lights up. The different numbering of
LED lights also indicate which CAREU P2 unit is currently connected to the P2 Station.
One P2 Station may pair up to maximum 4 units of CAREU P2.
P2 Station Pairing Mode: Storing CAREU P2 address into P2 Station memory.
Step 1. Powering up P2 Station, while in Scanning Mode, press and hold the "Link
Button" for 3 seconds to enter Pairing Mode.
When in Pairing Mode, if there are no previously stored pairing of CAREU P2
units, all LEDs (LED1/LED2/LED3/LED4) beings to flash (On:1 sec ,Off:1 sec).
Note: If the P2 Station is already stored with maximum 4 pairings of CAREU
P2 units, the number LEDs will flash in sequence LED1-> LED2->
LED3-> LED4 and then returns to Scanning Mode. User must delete
the previously paired CAREU P2 units before the P2 Station can pair
more units.
Step 2. If a CAREU P2 unit is found while in Pairing Mode, the P2 station
automatically stores the unit address into the number slot memory. The
numbering LED on the P2 Station will flash in sequence to indicate CAREU
P2 is newly paired (LED 1 flashes for 3s when first unit is paired, LED 2
flashes for 3 seconds if another unit is paired). If no CAREU P2 is found
within the proximity after 30 seconds the P2 Station automatically returns to
Scanning Mode.
Note: If there already existed previously paired CAREU P2 units, the
numbering LED will become solid light indicating the number slot is
already paired.
Delete Pairing Mode: Delete the paired CAREU P2 units stored in P2 Station
memory
Step 1. While P2 station is in Scanning Mode, press and hold both the Bluetooth
Button and Link Button together to enter Delete Mode, the numbering
LED will quickly flash in this order LED4-> LED3-> LED2-> LED1.
Step 2. Within 10 seconds time, press the “Bluetooth Button" again to confirm
delete and clear all previously stored CAREU P2 unit pairings. The numbering
LEDs will fast flash for 5 seconds (On:0.1 sec ,Off:0.1 sec) indicating all paired
units are successfully deleted before P2 Station returns to Scanning Mode.
BV Certificate Use
2017/02/06 17:09