User's Manual Part 1
Ronin-M
User Manual
14
©
2015 DJI. All Rights Reserved.
Step 1: Balancing the Vertical Tilt
To adjust the vertical balance, you will need to change the camera’s vertical position. Adjust the height
of the crossbar to achieve vertical tilt balance.
adjustment tabs.
2. Gently slide the camera mount crossbar forwards or backwards until the camera points upwards
when released.
3. Tighten the tabs and manually rotate the assembly, simulating tilt, to ensure there is no binding in
the tilt motor. When proper balance is achieved, you can rotate the camera to any tilt angle, and it
will stay in that position.
Balancing
match up, the assembly could possibly be skewed higher or lower on one side, which would
cause the tilt motor to bind.
Step 2: Balancing the Roll Axis
balance is achieved, the camera will stay level.
1. Loosen the two lock-knobs to allow the camera and mounting plate to slide left and right.
3. Tighten the two lock-knobs to lock the camera mounting plate in position.
When adjusting the roll balancing position of the camera, only loosen the two lock-knobs a
Step 3: Balancing the Tilt Axis