User's Manual

AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved. 10
Remote Controller Diagram
Using the Remote Controller
Turning the Remote Controller On and Off
The remote controller is powered by a 2S rechargeable battery that has a capacity
of 6000 mAh. The battery level is indicated via the Battery Level LEDs on the front
panel. Follow the steps below to turn on your remote controller:
1. When the remote controller is turned off, press the Power Button once. The
Battery Level LEDs will display the current battery level.
2. Press the Power Button once. Then press again and hold the Power Button to turn on the remote controller.
3. The remote controller will beep when it is turned on. The Status LED will rapidly blink green, indicating that the
[1] Antennas
Relays the aircraft control signals.
[2] Operation Status Display Panel
Displays the operation status.
[3] Control Stick
Controls the aircraft movement.
[4] Operation Mode Switch
Used to switch between Smart, Assisted and
Manual Operation Mode.
[5] Return-to-Home (RTH) Button
Press and hold this button to initiate Return-to-
Home (RTH).
[6] Battery Level LEDs
Display the current battery level.
[7] Status LED
Indicates whether the remote controller is linked
to the aircraft.
[8] Power Button
Used to power on/off the remote controller.
[9] RTH LED
Circular LED around the RTH button which displays
the RTH status.
[10] Flying Speed Dial
In Smart Operation Mode, turn and press the dial
to adjust the flying speed.
[11] Button A
Records the A Point of the operation route.
[12] Button B
Records the B Point of the operation route.
[13] Flight Mode Switch
Used to switch between G-Mode (GPS), A-Mode (Attitude) and M-
Mode (Manual).
[14] Spray Button
In MO-Mode, press to start / stop spraying.
[15] Spray Speed Dial
In MO-Mode, turn the dial to adjust the spray speed.
[16] Mini HDMI Port
Reserved.
[17] Micro USB Port
Reserved.
[18] CAN Port
Connects to the operation status display panel.
[19] USB Port
To update the firmware.
[20] GPS Module
Used to pinpoint the location of the remote controller.
[21] Back Left Button C1
Press to choose left as the direction of the operation route in SO-
Mode. In AO-Mode, press to fly the aircraft left by one operation
width.
[22] Power Port
Connects to a power source to charge the remote controller’s
internal battery.
[23] Back Right Button C2
Press to choose right as the direction of the operation route in
Smart Operation Mode. In AO-Mode, press to fly the aircraft right
by one operation width.
[2]
[10]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[21]
[22]
[23]
[20]
[1]