User's Manual

AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved. 19
Instructions
Ensure that the Operation Mode Switch is toggled to Manual Operation Mode, and then follow the instructions
below:
1. Recording Point A and B
Switch to the Smart Operation Mode only after Point A and B recorded.
Recording Point A First:
Fly the aircraft to the planning Point A and hover. Press Button A on the remote controller. The Point A LED on the
Operation Status Display Panel glows solid green and the Aircraft Status Indicator flashes red for eight times indicate
that Point A is recorded successfully.
Recording Point B Secondly:
Fly the aircraft to the planning Point B and hover. Press Button B on the remote controller. The Point B LED on the
Operation Status Display Panel glows solid green and the Aircraft Status Indicator flashes green for eight times
indicate that Point A is recorded successfully.
If you want to update Point B after Point A and B recorded, fly the aircraft to the new Point B and record it.
If you want to update Point A after Point A and B recorded, record the new Point A and then record Point
B again.
It’s recommended to keep the direction of Point A to B parallel to the long side of the rectangular spray
area for optimal effect.
2. Selecting the Orientation of Point C
Press Back Left Button C1 or Back Right Button C2 on the remote controller to select the orientation of Point C, C1
for left and C2 for right. The corresponding Orientation LED on the Operation Status Display Panel will be blinking
after selection. The orientation of Point C will be right if you didn’t press any of the C1 and C2 buttons.
3. Enabling Smart Operation Mode
Ensure that the Flight Mode Switch is toggled to GPS Flight Mode and the GPS signal is strong (the number of GPS
≥
6). Then toggle the Operation Mode Switch to Smart Operation Mode. The aircraft enters Smart Operation Mode
and hovers at Point B. The aircraft’s nose direction points to the direction of Point A to B automatically. The left and
right Orientation LED on the Operation Status Display Panel blinks.
The aircraft’s nose direction will point to the direction of Point A to B at all times without change by
the flying direction.
4. Starting Operation
The context below takes a right direction of Point C for example.
1) Press the Back Left Button C1 and Back Right Button C2 on the remote controller at the same time. The Aircraft
Status Indicator will flash blue for four times. The aircraft will fly from Point B to C and then hover at Point C. The