User's Manual

AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved. 21
automatically and resume the task before. Flight task resumption is suitable for liquid injection and battery
replacement.
The breaking point will be updated as long as the Operation Mode Switch is toggled from Smart
Operation Mode to any other mode.
Ensure that the GPS signal is strong (the number of GPS
≥
6) when using the flight task resumption
function. Otherwise, the aircraft cannot record and return to the breaking point.
Follow the instructions below to use this function:
1. Toggle the Operation Mode Switch to quit from Smart Operation Mode or initial the Failsafe RTH or Smart RTH
procedure. The current position of the aircraft will be recorded as the breaking point.
2. Fly the aircraft to a suitable altitude after other actions.
3. Ensure that the aircraft is in GPS Flight Mode and the GPS signal is strong (the number of GPS
≥
6). Then toggle
the Operation Mode Switch to enter Smart Operation Mode. The aircraft will return to the recorded breaking point
automatically and resume the task before.
System Data Memory
A data memory module is built in the MG-1 which can save the system data (position of Point A, B and the breaking
point) during about 1 minute after the aircraft powered off. Replace the batteries and restart the aircraft within the
available time. The data included Point A, B and the breaking point are still effective. Follow the instructions below
to use this function:
1. Toggle the Operation Mode Switch to quit from Smart Operation Mode. The current position of the aircraft will
be recorded as the breaking point.
2. Land the aircraft and stop the motors.
3. The system data memory function is activated automatically when the aircraft is powered off. The Aircraft Status
Indicator will glow solid red.
4. Replace the batteries within the available time (about 1 minute).
5. Restart the aircraft and toggle the Operation Mode Switch to enter the Manual Operation Mode.
6. Ensure that the aircraft is in GPS Flight Mode and the GPS signal is strong (the number of GPS
≥
6). Then start
the motors and fly the aircraft to a suitable altitude.
7. Toggle the Operation Mode Switch to enter Smart Operation Mode. The aircraft will return to the recorded
breaking point automatically and resume the task before.
DO NOT power off the aircraft for a long time (more than 1 minute) when using this function.
Otherwise, Point A, B and the breaking point will be lost.
Manual Operation Mode
Toggle the Operation Mode Switch to enter Manual Operation Mode. You can control all the movements of the